SNOW HOOD INSTALLATION PROCEDURE
Installing the upper part of snow hood
z
The upper part of snow hood can be installed in the same manner as for the duct. For
●
details such as where to fix it, see the duct installation procedure.
Using the fixing positions on the top panel, install the components such as the frame,
●
column, front panel, top panel, and rear panel.
Installing the sides of snow hood
z
Before starting snow hood installation, remove the screws from the external net to remove
●
the net.
Install the snow hood, using the screw holes shown in the figure on the next page.
●
Remove the screws from where circles are marked in the figure, and make a ø4.6mm hole
●
in each dowel.
Use ø5 tapping screws having a thread length of 10 to 20mm.
●
Do not remove any screws from where a circle is not marked.
●
Do not make a hole in the dowels where a circle is not marked. Otherwise, damage to the internal
●
parts will cause performance degradation or trouble.
Caution
- (02 - 33) -