Travis Industries 1750 Wood Owner's Manual page 13

Fireplace Insert Installation
3. Place the insert into the fireplace and connect the flue (if using a positive or direct connection). Install
the top panel and trim following the directions below.
Spring
Clips
Install the top panel so the tabs insert
into the joggle clips on the top panel
© Travis Industries
Top
Panel
100-01234
(for qualified installers only)
Top Trim
"L" Bracket
Right Side
Trim
Optional Trim Installation:
Insert one leg of each "L" bracket into the top
and side trim piece. Align the trim to form a
precise corner, then tighten the two set
screws with a small standard screwdriver.
Slide the trim over the panels. Place the
spring clips behind the panels at the locations
shown. This keeps the trim tight against the
panel.
Optional Knock-Out
An optional knock-out is provided on both
sides if the power cord is routed behind the
surround panel.
13
Micro (1/16")
Standard
Screwdriver
4101210