Macro Key Programming
Use the following procedure for macro key programming :
Mode position/Auto key no.
The Macro Key Function is used to run a series of instructions with a single key stroke. You can program up to 15
modes auto key numbers for each macro key.
Procedure
Select a pertinent
macro key.
Program the item as follows:
• MACRO#1 thru MACRO#4 (Use the selective entry method)
Select the pertinent macro key from the list.
• MODE#1 thru MODE#15 (Use the selective entry method)
INHIBIT:
PGM2:
PGM1:
OPXZ:
REG:
X1Z1:
X2Z2:
• KEY#1 thru KEY#15 (Use the selective entry method)
INHIBIT:
AUTO1 thru AUTO99: AUTO key no.
ENTER
AUTO key is inhibited.
PGM2 mode
PGM1 mode
OP X/Z mode
REG mode
X1/Z1 mode
X2/Z2 mode
AUTO key is inhibited.
— 229 —