Non-Accessed Upc And Customer Deletion - Sharp UP-820F Instruction Manual

Pos terminal
Hide thumbs Also See for UP-820F:
Table of Contents

Advertisement

Non-accessed UPC, Dynamic
11
UPC and Customer Code
Deletion
You can delete UPCs and customer codes that have not been accessed for a certain period. You can
program this period in the PGM2 mode. As for customer codes, you can delete any customer code with
regardless of the non-accessed period.
Follow the procedure below.
Non-accessed UPC deletion
1. Enter the X1/Z1 mode from the mode selection window.
2. Select "2 RESETTING ".
3. Select "8 NON ACCESSED UPC" to delete non-accessed UPCs.
4. When you select"8 NON ACCESSED UPC", select whether to delete all the non-accessed UPCs at a time
(1 ALL DELETE) or delete the non-accessed UPCs individually (2 IND.DELETE).
It is recommended that you first take a report before deleting operation.
NOTE
Dynamic UPC clear
1. Enter the X1/Z1 mode from the mode selection window.
2. Select "2 RESETTING".
3. Select "9 D-UPC CLEAR" to clear a designated range of UPCs, "10 D-UPC CLEAR PICK" to pick up codes
one by one to clear them (see the "NOTE" on page 91), or "11 D-UPC CLEAR DEPT" to clear codes on an
associated department basis.
Non-accessed customer deletion
1. Enter the X2/Z2 mode from the mode selection window.
2. Select "5 NON ACCESS. CUST.".
3. Select "1 READING" to take a report, or "2 DELETE" to delete non-accessed customer codes.
4. When you select "2 DELETE", select whether to delete all the non-accessed customer codes at a time (1
ALL DELETE) or delete non-accessed customers codes individually (2 IND.DELETE).
It is recommended that you first take a report before deleting operation.
NOTE
Customer code deletion
1. Enter X2/Z2 mode from the mode selection window.
2.
S
e
e l
t c
6 "
C
U
S
T
3. Specify the range (start/end customer codes) you want to delete.
O
M
E
R
D
E
L
E
T
. " E
— 117 —
X1/Z1 MODE
X2/Z2 MODE

Advertisement

Table of Contents
loading

This manual is also suitable for:

Up-810fUp-820n

Table of Contents