Reinstalling The Drive Housing - Epson ExpressStation User Manual

Be careful not to bump the housing into the main system board
or the option card riser board on its left side.
Caution
Do not drop the drive housing or handle it roughly; this
could damage your disk drives or the connectors.
Also, do not install or remove option cards when the
drive housing is removed from the computer. The
housing stabilizes the option card riser board and it
could be severely damaged if you put stress on it
without the support of the drive housing.
3. Turn the drive housing over and set it aside. Then follow the
appropriate instructions in Chapter 3 to access your main
system board or to install disk drives.

Reinstalling the Drive Housing

Follow these steps to reinstall the drive housing inside the
computer:
1, Position the housing so the disk drive riser board connector
faces down and the diskette drive faces the front of the
computer.
Caution
Do not drop the drive housing or handle it roughly; this
could damage your disk drives or the connectors.
2-6 Accessing Internal Components