Option Package Contents; Installation Tools - YASKAWA SI-N3/V Technical Manual

3 Receiving
• Make sure that the model number on the option nameplate and the model number on the purchase order are the
same. Refer to Figure 4.1
• Contact the distributor where you purchased the option or contact Yaskawa or a Yaskawa representative about
any problems with the option.
◆

Option Package Contents

LED label
*1 GA700 and GA800 drives do not use the ground wire.
*2 Only two screws are necessary to install the option on GA700 and GA800 drives.
Note:
The LED label for FP605 drives is packaged with the FP605 drive.
◆

Installation Tools

You can use these tools to install the option to the drive:
• A Phillips screwdriver or slotted screwdriver (M3
• A flat-blade screwdriver (blade depth: 0.4 mm (0.02 in.), width: 2.5 mm (0.1 in.)).
• A pair of diagonal cutting pliers.
• A small file or medium-grit sandpaper.
*1 Phillips screw sizes are different for different drive capacities. Prepare different screwdrivers for different
screw sizes.
10
for more information.
Table 3.1 Contents of Package
Option Contents
Option
*1
Ground wire
Screws (M3)
1000-Series, Z1000U
GA500, GA700, and GA800
Manuals
Figure 3.1 LED Label for FP605
)
*1
YASKAWA SIEP C730600 84G DeviceNet Technical Manual
Quantity
1
1
*2
3
1
1
1