A.1 PoE RJ45 Port Pin Assignments
A.2 Switch's Data RJ45 Pin Assignments - 1000Mbps, 1000BASE-T
PIN NO
1
2
3
4
5
6
7
8
Implicit implementation of the crossover function within a twisted-pair cable, or at a wiring panel, while not expressly
forbidden, is beyond the scope of this standard.
A.3 10/100Mbps, 10/100BASE-TX
When connecting your Switch to another Fast Ethernet switch, a bridge or a hub, a straight or crossover cable is
necessary. Each port of the Switch supports auto-MDI/MDI-X detection. That means you can directly connect the Switch
to any Ethernet devices without making a crossover cable. The following table and diagram show the standard RJ45
receptacle/connector and their pin assignments:
PIN NO
1
2
3
4, 5
6
7, 8
APPENDIX A: Networking Connection
PIN NO
RJ45 POWER ASSIGNMENT
• Power +
1
• Power +
2
• Power -
3
• Power -
6
MDI
BI_DA+
BI_DA-
BI_DB+
BI_DC+
BI_DC-
BI_DB-
BI_DD+
BI_DD-
RJ45 Connector pin assignment
MDI
Media Dependent Interface
Tx + (transmit)
Tx - (transmit)
Rx + (receive)
Rx - (receive)
User's Manual of WGSW-48040HP
MDI-X
BI_DB+
BI_DB-
BI_DA+
BI_DD+
BI_DD-
BI_DA-
BI_DC+
BI_DC-
MDI-X
Media Dependent Interface-Cross
Rx + (receive)
Rx - (receive)
Tx + (transmit)
Not used
Tx - (transmit)
Not used