Hanna Instruments HI 23 Series Instruction Manual page 49

KDS
KDW
KRG
KST
KUP
MDR
ECR
TDR
RNG
TMR
PWD
SET
If the controller is not in control or idle mode and the tem-
Note
perature reading is requested through the TMR command,
the controller answers with the last acquired reading when it
was in control or idle mode.
Following are examples of commands for setup items:
"03SET22+01200<CR>" "03SET22+01200<CR>" "03SET22+01200<CR>" "03SET22+01200<CR>" "03SET22+01200<CR>"
This command sets the setup item 22 (relay 2 set point) of a
EC controller, identified by the process ID number 03, to the
+12.00 mS value.
null Same as LCD key
null Same as key
null Same as key
null Same as SETUP key
null Same as key
null Request firmware code
null Request EC reading (available in
control or
null Request TDS reading (available
in control
HI 24 series only)
null Request measure Range
(available in
or idle mode only)
null Request temperature reading
NNNN Send the 4-digit password
NNPC C C C C Set setup item NN to the PC
1 2 3 4 5
value; P=+ if the value is greater than 0, P=- if the value
is less than 0. C can be 0 or 1; only C
1
or blank (the command is not available if the controller is in
setup mode)
idle mode only)
or idle mode only, for
control
C C C C
1 2 3 4 5
C C C can be 0 to 9
2 3 4 5
49