Table of Contents
Advertisement
3.2. System configuration with NJ and NX safety controller
■ EtherCAT node address configuration
1.
Please configure the EtherCAT node address of the drive to 1.
Note: You can configure the node address depending on your application
2.
In case of using NX safety, please configure the node address of the NX coupler to
2.
Note: You can configure the node address depending on your application
3.
Please connect EtherCAT cables to devices
CN10 EtherCAT IN: EtherCAT cable from NJ EtherCAT Master
CN11 EtherCAT OUT: EtherCAT cable to NX coupler unit
Additional Information
For further details about safety controller, please refer to the NX-series safety control
units user manual Z930
25
Advertisement
Table of Contents
