Table of Contents
Advertisement
Figure 6-4
3.
Secure back rail (A, Figure 6-5) to pre-tapped
holes in saw table (B) in two places with
M8x20 socket hd cap screws and washers.
Finger tighten only.
4.
Use the adjustable square to measure at
several points along rail to achieve parallel
with table. Tighten screws securely with 13mm
wrench.
Figure 6-5
Important: If you are installing an optional wood
extension table on your saw, it should be installed
first before mounting guide tube. This will prevent
having to mount and align the guide tube twice.
If you are not mounting an optional wood table,
proceed to sect. 6.5, Installing guide tube.
6.4 Installing wood extension table
(optional accessory)
6.4.1 Tools required for assembly
Electric drill
Philips screwdriver
Open-end wrenches, 10mm, 13mm
Hex wrenches, 5mm, 6mm
Four clamps
Straight edge
Rubber mallet (or hammer with block of wood)
6.4.2 Installing table legs
Legs are optional accessories. If your wood table
does not require legs, proceed to sect. 6.4.3.
Place the optional wood extension table upside
down. (Use a mat or cloth to protect the surface).
Installing on PM2000B (folding legs):
1.
Install leg brackets to the pre-drilled holes,
using screws provided with the legs.
2.
Press both ball detents (A, Figure 6-6) and
swing leg until it "clicks" into position.
3.
Turn wood table right-side up.
4.
The levelers at bottom of legs can be rotated
to help level wood table with saw during the
following procedure.
Figure 6-6: for PM2000B
Installing on PM3000B (non-folding legs):
1.
Position legs at inside corners of wood table at
the end where the Powermatic logo is placed.
See Figure 6-6b).
Note: If you are using a mobile base under
your saw, you may need to shift the placement
of the legs so that they rest properly upon the
shelves of the base.
2.
Drill pilot holes, making sure not to drill
completely through table and sides.
3.
Secure with the eight screws provided.
4.
Turn wood table right-side up.
5.
The levelers at bottom of legs can be rotated
to help level wood table with saw during the
following procedure.
Figure 6-6b: for PM3000B
9
Advertisement
Table of Contents
