Table of Contents
Advertisement
Figure 7-3
5.
Check height of front rail at several locations
along surface of table. The measurements
should be the same along the length of the rail.
Adjust as needed.
6.
When front rail has been correctly positioned,
and your mark still lined up with the straight
edge, drill 1/4" holes into lip of table saw top,
using holes in front rail as guide (Figure 7-4).
7.
Lightly secure front rail to saw table with four
M8x40 flat head screws with washers and hex
nuts (Figure 7-5). Finger-tighten only.
Figure 7-4
Figure 7-5
7.3 Installing back rail
1.
Locate the back rail which is 2" x 2" with holes
running along one side only. The height of the
back rail when attached to the saw is not
critical, but it should be parallel to table top.
2.
Position back rail approximately 9/16" below
table surface, with the ends even with those of
front rail (Figure 7-6). Hold back rail to saw
with clamps.
3.
Drill 9mm (or 11/32") holes into lip of saw table
using holes in back rail as guide (Figure 7-7).
4.
Insert socket head cap screws with washers
through back rail and saw table, and secure
with washers and hex nuts. See Figure 7-8.
Finger-tighten only at this time.
The rest of the installation is the same as with a
Powermatic table saw. Refer back to sect. 6.4 to
mount the optional wood extension table (if
applicable) and the guide tube in sect. 6.5, and
proceed from there.
14
Figure 7-6
Figure 7-7
Figure 7-8
Advertisement
Table of Contents
