APRILIA TUAREG 660 Instruction Manual page 168

CAUTION
WARNING
AFTER HEAVY RAIN, WASHING OR IN CASE OF RAPID TEMPERATURE
CHANGES, THE LENSES OF THE FRONT LIGHT ASSEMBLY MAY BECOME
FOGGY.
THIS STATE IS DUE TO THE TEMPERATURE DIFFERENCE BETWEEN THE
OUTSIDE AND THE INSIDE AND DOES NOT INDICATE A FAULT OF THE FRONT
LIGHT ASSEMBLY.
To remove dirt and mud accumulated on painted surfaces, wet the soiled areas thor-
oughly with a low-pressure water jet, then remove dirt and mud with a soft car body
sponge soaked abundantly in a solution of car body shampoo in water (2 - 4% sham-
poo dissolved in water). Then rinse with plenty of water, and dry with a chamois
leather.
Use neutral soap and water to clean the external parts of the engine and the parts in
anodized or painted aluminium. Using aggressive detergents may damage the surface
treatment of these components.
Cleaning must only be done with the engine cold.
04_30
FAILURE TO COMPLY WITH THESE INDICATIONS MAY LEAD, IN CERTAIN CA-
SES, TO THE VARIATION IN THE SHADE OF THE TREATED SURFACE AND
CONSEQUENTLY TO THE VOID OF THE WARRANTY.
TO CLEAN THE LIGHT ASSEMBLIES, USE A SPONGE SOAKED IN WATER AND
MILD DETERGENT, GENTLY RUBBING THE SURFACE AND RINSING FRE-
QUENTLY WITH PLENTY OF WATER.
DO NOT CLEAN THE FRONT LIGHT ASSEMBLY WITH DETERGENTS CONTAIN-
ING TENSIOACTIVE AGENTS AND/OR ALCOHOL.
04_31
REMEMBER TO CLEAN THE VEHICLE CAREFULLY BEFORE APPLYING SILI-
CON WAX POLISH. DO NOT POLISH MATT-PAINTED SURFACES WITH POL-
ISHING PASTE. THE VEHICLE SHOULD NEVER BE WASHED IN DIRECT
168