APRILIA TUAREG 660 Instruction Manual page 147

IF THE BRAKE LEVER STROKE IS EXCESSIVE OR EXCESSIVELY ELASTIC, OR
IF THERE ARE AIR BUBBLES PRESENT IN THE BRAKE CIRCUIT, CONTACT AN
Official Moto Guzzi Dealer, SINCE IT MAY BE NECESSARY TO BLEED THE AIR
IN THE CIRCUIT.
•
Unscrew and remove the cap (4)
NOTE
TO AVOID SPILLING BRAKE FLUID WHILE TOPPING-UP, KEEP THE FLUID IN
THE RESERVOIR PARALLEL TO THE EDGE OF THE RESERVOIR (IN HORIZON-
TAL POSITION).
04_07
•
Remove the gasket (5).
•
Using a syringe, top up until the correct level is reached, between the two
references "MIN" and "MAX".
CAUTION
ONLY FILL TO THE "MAX" LEVEL AFTER FITTING NEW BRAKE PADS. FLUID
LEVEL DECREASES GRADUALLY AS BRAKE PADS WEAR DOWN.
DO NOT FILL TO THE "MAX" LEVEL WITH WORN PADS, AS THIS WILL CAUSE
FLUID TO ESCAPE WHEN REPLACING BRAKE PADS.
•
To reassemble the components, follow the procedure in reverse.
147