Lexus ES-300 2001 Manual page 107

INTERIOR EQUIPMENT
3. Press and release the vehicle's programmed
R
HomeLink button twice. The garage door may open.
If the door does open, the programming process is
complete. If the door does not open, press and release
the button a third time. This third press and release will
complete the programming process by opening the
garage door.
The ceiling mounted garage door opener motor should
now recognize the HomeLink
the garage door up/down.
4. Repeat steps 1 through 3 for each remaining
R
HomeLink button to program another rolling code
system.
Programming an entrance gate /
Programming all devices in the Canadian
market
1. Decide which of the 3 HomeLink
to program.
2. Place your hand–held gate/device transmitter 25 to
75 mm (1 to 3 in.) away from the surface of the
R
HomeLink .
Keep the indicator light on the HomeLink
programming.
3. Press and hold the selected HomeLink
4. Continuously press and release (cycle) the
hand–held gate/device transmitter button every two
90
R
unit and be able activate
R
buttons you want
R
in view while
R
button.
seconds until step 5 is complete.
5. When the indicator light on the HomeLink
from a slow to a rapid flash after 20 seconds, you can
release both buttons.
R
changes