Lexus ES-300 2001 Manual page 106

The battery side of the hand–held transmitter must be
pointed away from the HomeLink
programming process.
For Canadian users, follow the procedure in
"Programming an entrance gate/Programming all
devices in the Canadian market".
1. Decide which of 3 HomeLink
program.
2. Place your hand–held garage transmitter 25 to 75
mm (1 to 3 in.) away from the surface of the HomeLink
Keep the indicator light on the HomeLink
programming.
3. Simultaneously press and hold the hand–held garage
transmitter button along with the selected HomeLink
button.
4. When the indicator light on the HomeLink
from a slow to a rapid flash after 20 seconds, you can
release both buttons.
5. Test the operation of the HomeLink
newly programmed button. If programming a garage
door opener, check to see if the garage door opens and
closes.
If the garage door does not operate, identify if your
R
during the garage transmitter is of the "Rolling Code" type. Press
and hold the programmed HomeLink
garage door has the rolling code feature if the indicator
light (on the HomeLink
remains lit after 2 seconds. If your garage transmitter is
the "Rolling Code" type, proceed to the heading
R
buttons you want to "Programming a rolling code system".
6. Repeat steps 2 through 5 for each remaining
HomeLink
R
.
Programming a rolling code system
R
in view while
If your device is "Rolling Code" equipped, it is
necessary to follow steps 1 through 4 under the
heading "Programming the HomeLink
R
proceeding with the steps listed below.
R 1. Locate the "training" button on the ceiling mounted
changes
garage door opener motor. The exact location and color
of the button may vary by brand of garage door opener.
Refer to the owner's guide supplied by the garage door
R
by pressing the
opener manufacturer for the location of this "training"
button.
2. Press the "training" button on the ceiling mounted
garage door opener motor.
Following this step, you have 30 seconds in which to
initiate step 3 below.
INTERIOR EQUIPMENT
R
button. The
R
) flashes rapidly and then
R
button to program another device.
R
" before
89