Cables And Connectors - Mitsubishi Electric MR-J2S B Series Instruction Manual

12. OPTIONS AND AUXILIARY EQUIPMENT

12.1.5 Cables and connectors

(1) Cable make-up
The following cables are used for connection with the servo motor and other models.
The broken line areas in the diagram are not options.
Servo system
controller
(Note 1)
Connector set
3) 4) 5)
Note 1. The bus cable used with the SSCNET depends on the preceding or subsequent controller or servo amplifier connected.
Refer to the following table and choose the bus cable.
QD75M
Q172CPU(N)
Motion
Q173CPU(N)
controller
A motion
MR-J2S- B
MR-J2-03B5
Maintenance junction card
2. The cable and connector are used for only servo amplifier of 11kW or more.
Servo amplifier
(Note 1)
CN1A CN1B
Bus cable
CN2 CN3
CON2
22)
(Note 2)
HA-LFS
7) 8)
MR-J2S-
10) Bus cable :MR-J2HBUS
24) Bus cable :Q172J2BCBL
25) Bus cable :Q173J2B
9) Bus cable :MR-J2HBUS
10) Bus cable :MR-J2HBUS
(Note 1)
Bus cable
CN4
(Note 1)
23) (Note 2)
To U, V, W
20) 21)
1) 2)
6)
16) 17) 18)
19)
3) 4) 5)
7) 8)
B
M
M(-B)
CBL M
M-A
M
12 - 23
Servo amplifier
13)
CN1A CN1B
Termination connector
CN2 CN3
15)
14)
HC-KFS
HC-MFS
HC-UFS 3000r/min
HC-SFS
HC-RFS
HC-UFS 2000r/min
MR-J2-03B5
12) Connector set:MR-J2CN1
11) Connector set:MR-J2CN1-A
12) Connector set:MR-J2CN1
Personal computer