Auto Connection; Device List And Connection - AT&T DL72130 Complete User's Manual

Bluetooth
Bluetooth setup

Auto connection

When an active device moves within Bluetooth range of the telephone base,
or is turned on within range, the telephone base tries to connect to the device.
When the device moves out of range, it is disconnected. Your device might
make a connect or disconnect sound.
A connected device could also be disconnected by:
Turning off the Bluetooth device.
f
Turning off the Bluetooth feature of the device.
f
The Bluetooth device is not within range of the telephone base.
f

Device list and connection

Up to two devices can be paired to the telephone base. All paired devices are
shown on the device list. To use a paired device, it must be connected and in an
active slot (1: or 2:) on the device list. Only one active device can be on a call at
a time.
Once you have paired a device with the telephone base, you do not need to
repeat the pairing procedure again unless you delete the device from the
device list.
Note: When connecting a Bluetooth device to the device list, all connected devices will be temporarily
disconnected until the procedure is complete. It may take up to two minutes to reconnect.
22