AT&T DL72130 Complete User's Manual page 133

Appendix
Screen messages
** Paging **
Put in charger
Quiet mode off
Quiet mode on
Rec mem low
Rec mem full
Ringer muted
Screen all
Robocalls
Screen all
Unknown calls
Screened call
Setting Ans sys
Smart call blk
screening...
Speaker
Voice guide set
Smart call blk?
To register HS...
...see manual
To screen call
press [SELECT]
Unable to call
XX missed calls
XX new messages
The telephone base is paging all handsets.
The battery is very low. The handset should be placed in the
telephone base or charger.
The quiet mode is turned off.
The quiet mode is turned on.
The answering system has less than 3 minutes to record.
The answering system memory is full.
The ringer is muted temporarily during an incoming call.
You have selected the Screen robot profile option in Smart call
blocker.
You have selected the Screen Unknown profile option in Smart call
blocker.
The Smart call blocker feature of the telephone has screened a call
and is putting the call through to you.
The handset is playing voice guide.
The telephone is screening an incoming call.
The handset speakerphone is in use.
After you install your telephone or power returns following a power
outage, the handset and telephone base will prompt you to set the
date and time. After the date and time setting is done or skipped,
the telephone base will then prompt if you want to set up the
Smart call blocker feature via voice guide.
The handset is not registered to any telephone base.
The system is recording a message. Press
call on a handset.
Intercom failed.
X
You try to make a call when the handset is out of range.
X
There are XX new calls in the caller ID log.
There are XX new messages in the answering system.
127
/SELECT to screen a
MENU