Table of Contents
Advertisement
1) Refrigerant piping
2) Part to be brazed
3) Taping
4) Hands valve
5) Pressure-reducing valve
6) Nitrogen
For details, see manual of the outdoor unit.
(3) Make sure to cool the filters and valve body with a wet cloth and make sure the body temperature does not
exceed 120°C(248°F) during brazing.
(4) Make sure that the other parts such as electrical box, tie wraps and wires are protected from direct brazing
flames during brazing.
(5) The EXV box is required to be installed in a vertical direction within the range of 90±15° (not allowed for
horizontal work). Welding the connection tubes first before refrigerant pipes in order to avoid face-down
soldering.
(6) All field piping must be provided by a licensed refrigeration technician and must comply with the relevant
local and national codes.
a) For refrigerant piping of outdoor unit, refer to the installation manual supplied with the outdoor unit.
b) The maximum allowed piping length depends on the connected outdoor model.
(4) Secure the wire clamp (C) in place again (6×M4.2).
(5) Make sure that field pipes are fully insulated. Make sure that there is no gap between both
ends in order to avoid condensation dripping (finish the connection with tape eventually).
4.2.3 Installation handbook of the EXV cable
4.2.3.1 Installation steps
(1) Making the cable terminal through the Cable-Cross Loop (Fig.4.2.2), and then winding the
cable on the magnetic ring for three times(Fig.4.2.3), at last inserting the terminal into a
corresponding slot(see circuit diagram).
(2) Using bundles to fix the magnetic ring is required. It's also need to insert the bundle into
the reserved hole on the control box.
(3) Fixing the cable with the wire clamp, and tightening the Cable-Cross Loop.
(4) Fix the magnetic ring to the reserved hook fixing inside electrical box with
high-temperature bonding tie.
(5) Screw the joint.
NOTICE
23
AHU-KIT
Advertisement
Table of Contents
