Drying Programme Finished - Asko Professional TDC145HPS Operating Instructions Manual

TUMBLE DRYING
PRESS THE START BUTTON.
An estimate of the remaining drying time will be shown
on the display a few minutes after the drying programme
starts. For example, 1:35 means that it will take
approximately 1 hour and 35 minutes for the load to dry.
If the option.Anti crease has been selected, the drum will
rotate for three seconds per minute for two hours after
the programme is fi nished. The actual remaining time
may be longer than the estimated time shown on the
display. The remaining time is then shown as 0:15 until
the load is suffi ciently dry. If you selected Time Saver the
display will show 0:05 instead. You can stop the tumble
dryer by pressing the Stop button for three seconds or
by opening the door. In both cases the programme is
stopped and starts from the beginning if restarted.
NOTE!
The programme will not be aff ected if you change the
programme selector after the programme has started.

DRYING PROGRAMME FINISHED

The text Done appears on the display when the
programme is fi nished. If the Anti crease option has
been selected, the drum will rotate for three seconds per
minute for two hours after the programme is fi nished.
The compressor's cooling fan continues to run after the
programme fi nishes, but stops automatically or when
any button/knob is activated.
Backlighting
Two minutes after the drying programme fi nishes the
backlighting on the display and options buttons enters
energy saving mode. Turn the programme selector if you
want to activate the machine.
Condensed water
The condensed water container must be emptied after
each load. Remove the condensed water container,
empty out the water and replace the container. If the
condensed water container becomes full to overfl owing,
the programme is interrupted and Over Flow appears
on the display. Empty the container and press the Start
button to start a new programme.
TIP!
The condensed water is decalcifi ed and can be used in
steam irons. Pour it through a coff ee fi lter.
10
Automatic emptying
For connection to a separate drain, see the installation
instructions in the set of documents.
TIP!
Clean the lint fi lter in the outer door after each load.
See the Care and cleaning chapter.
WARNING!
If the lint fi lter becomes clogged, the machine's
automatic overheating cut-out may be triggered.
Clean the fi lter, wait until the machine has cooled
then try starting it. If it still does not start: Call the
service division.
Once drying has fi nished
Turn off the main power switch. Remove the clothes and
close the door to prevent small children from climbing
into the machine.