Charging Procedure From; (Ac/Dc) - Jeep AVENGER 2023 Owner's Handbook Manual

The red indicator lamp next to the
charging port comes on to indicate that
the connector is locked.
CANCELLING THE CHARGING
PROCESS
WARNING At public charging stations,
the cancelling and subsequent resuming
of the charging process may cause
additional costs.
Once the charging process has started,
only the driver's door can be unlocked
without cancelling the charging process.
Therefore, activate the driver's door only
function in the vehicle personalisation.
Press on the remote control to cancel
the charging process at any time.
Press twice to to cancel the charging
process at any time if the driver's only
function is activated.
STOP CHARGING
245)
Before disconnecting the plug from
the charging connector: if the vehicle
is locked, unlock it; if the vehicle is
unlocked, lock it and then unlock it
fig. 249.
178
249
The red indicator lamp next to the
charging port goes out to confirm that
the connector is unlocked.
250
Disconnect the vehicle plug of the
charging cable from the charging
port fig. 250 within 30 seconds after
unlocking.
The end of charging is confirmed by
the accelerated charging unit (Wallbox)
and when the green light close to the
charging port come on fixed.
After disconnection, replace the
connector on to the charging unit and
close the charging flap.
WARNING
245) After the end of the charging
progress: disconnect the charging cable
from the charging port of the vehicle;
make sure the charging port flap is
closed; always disconnect the charging
JJ000654
cable from the domestic electrical outlet;
avoid any entry of fluids into the charging
port of the vehicle, the vehicle plug of
the charging cable and the domestic
electrical outlet.
CHARGING PROCEDURE
FROM PUBLIC CHARGING
STATION (AC/DC)
When charging at a public AC charging
station / public DC charging station,
follow the instructions for the use of the
respective charging station. Public AC
charging stations may not provide an
JJ000473
integrated charging cable. In this case,
a portable mode 3 charging cable is
required.
Shift the PRND command into P and
switch off the vehicle
engage the electric parking brake
take the charging kit located in the
boot