Table of Contents
Advertisement
32
33
remove the protective cover (B) fig. 33
of the charging port and attach it to the
device (C)
grasp the charging connector (D) by
the handle, remove the protective cover
(where provided) and insert it into the
charging port (E) until you hear the click
indicating that it has been locked
charging starts automatically if no
scheduled charging has been set (see
the "Charging functions" chapter in the
online Owner Handbook). If scheduled
charging has been set, press the button
(B) fig. 34 on the charging port or use
the dedicated App installed on your
smartphone
observe the LEDs on the cable control
unit to check that there are no faults
in the charging system (see "Charging
J0A6030E
status control unit" in the "Power
sources that can be used - Mode 2
cable" chapter of the online Owner
Handbook for more information). If
there are no anomalies, the green LEDs
located next to the charging socket will
light up at the same time
NOTE The charge procedure is interrupted
when opening the bonnet: a dedicated
message will be shown on the instrument
panel display. The charge will be reactivated
when the bonnet is closed correctly.
J0A6086E
WARNING Use only the charging cable
supplied with the car or a replacement
cable recommended by FCA.
WARNING Not all AC charging stations are
compatible for charging. In these cases,
charging will not take place although
the cable is connected correctly and a
dedicated message will be displayed on the
instrument panel display.
WARNING The high-voltage battery must be
charged in accordance with the maximum
ampere rating allowed by local and national
recommendations for charging electric/
hybrid cars.
END OF CHARGING PROCEDURE
The charging procedure ends when all
the LEDs (A) fig. 34, located next to the
charging port, will light up in green with a
steady light (during the charging phase the
first LED will flash, while the other LEDs will
be on with a steady light).
34
J0A2409C
25
Advertisement
Table of Contents
