Setup Linking 4286A and Chip Handler
The 4286A can be set up to read initial settings from
exible disk during startup. This setup
allows the 4286A to run exclusively for your particular purpuse, the chip handler for instance,
from the moment of startup.
Follow the procedure below.
1. Set up the 4286A for use with the handler.
2. Insert a 3.5-inch LIF or DOS-formatted disk into the built-in disk drive.
3. Press
.
4
Save/Recall
5
4. Press
NNNNNNNNNNNNNNNNNNNNNNNNNN
STOR DEV to switch it to
destination.
NNNNNNNNNNNNNNNNN
5. Press
STATE .
6. Enter AUTOREC as the lename and press
Before turning on the 4286A, insert the disk containing the \ AUTOREC " le into the built-in disk
drive. Each time you turn on 4286A, it recalls settings in the le to operate exclusively for the
handler from the moment of startup.
4-10
4286A with Chip Handler
NNNNNNNNNNNNNNNNNNNN
[DISK] . This species the built-in disk drive as the storage
NNNNNNNNNNNNNN
DONE .