Notices And Licences For Software Used In This Product - Sony LMD-A240 Operating Instructions Manual

LMD-A180
* Length of M4 screws (side, rear)
# Length of M4 screws (rear)
Monitor cabinet
Notes
 Make sure to tighten the screws using the screwdriver
which conforms to the supplied screws.
When using an electric screwdriver, set the torque

setting as follows.
For M4 screws: approximately 1.2 N·m [12 kgf·cm]
 When installing on a vehicle, secure the unit to the
vehicle using the M4 screw holes on the sides of the
unit.
(The tilt angle is within 10° of the angle of depression)
1 11
* 6 ( / ) to 8 ( / )
4 32
13 9
# 10 ( / ) to 14 ( / )
32 16
M4 screw
Attached object
Unit: mm (inches)
NOTICES AND LICENCES
FOR SOFTWARE USED IN
THIS PRODUCT
uSSH (Secure Shell) SDK
Copyright (C) 2009-2019 Cypherbridge Systems, LLC.
All Rights Reserved.
www.cypherbridge.com
--------------------------------------------
Dropbear contains a number of components from
different sources, hence there are a few licenses and
authors involved. All licenses are fairly non-restrictive.
The majority of code is written by Matt Johnston, under
the license below.
Portions of the client-mode work are (c) 2004 Mihnea
Stoenescu, under the same license:
Copyright (c) 2002-2008 Matt Johnston
Portions copyright (c) 2004 Mihnea Stoenescu
All rights reserved.
Permission is hereby granted, free of charge, to any
person obtaining a copy of this software and associated
documentation files (the "Software"), to deal in the
Software without restriction, including without
limitation the rights to use, copy, modify, merge,
publish, distribute, sublicense, and/or sell copies of the
Software, and to permit persons to whom the Software
is furnished to do so, subject to the following conditions:
The above copyright notice and this permission notice
shall be included in all copies or substantial portions of
the Software.
THE SOFTWARE IS PROVIDED "AS IS", WITHOUT
WARRANTY OF ANY KIND, EXPRESS OR
IMPLIED, INCLUDING BUT NOT LIMITED TO
THE WARRANTIES OF MERCHANTABILITY,
FITNESS FOR A PARTICULAR PURPOSE AND
NONINFRINGEMENT. IN NO EVENT SHALL THE
AUTHORS OR COPYRIGHT HOLDERS BE LIABLE
FOR ANY CLAIM, DAMAGES OR OTHER
LIABILITY, WHETHER IN AN ACTION OF
CONTRACT, TORT OR OTHERWISE, ARISING
FROM, OUT OF OR IN CONNECTION WITH THE
SOFTWARE OR THE USE OR OTHER DEALINGS
IN THE SOFTWARE.
==============

NOTICES AND LICENCES FOR SOFTWARE USED IN THIS PRODUCT

41