Sony LMD-A240 Operating Instructions Manual page 26

[Chroma]
Press the button to display the adjustment screen and
adjust the color intensity. Press again to hide the
adjustment screen. However, the color intensity remains
adjustable. Turn the menu selection control right to
increase the intensity, or left to decrease it.
[Phase]
Press the button to display the adjustment screen and
adjust the color tones. Press again to hide the adjustment
screen. However, the color tones remain adjustable. Turn
the menu selection control right to increase the green
tone, or left to increase the purple tone.
[Aperture]
Press the button to display the adjustment screen and
sharpen the picture outline. Press again to hide the
adjustment screen. However, the picture sharpness
remains adjustable. Turn the menu selection control
right to make the picture sharper, or left to make the
picture softer.
[Volume]
Press the button to display the adjustment screen and
adjust the volume. Press again to hide the adjustment
screen. However, the volume remains adjustable. Turn
the menu selection control right to increase the volume,
or left to decrease it.
[Closed Caption]
Press the button to display the closed caption. Set the
closed caption setting in the [Closed Caption Setting]
menu (see page 31).
[IMD] (In-Monitor Display)
When using external remote devices, the source name or
tally information is displayed on the monitor screen.
Adjust the setting in [In-Monitor Display Setting].
[User Preset1]
[User Preset2]
[User Preset3]
[User Preset4]
[User Preset5]
Press the button to load the settings saved in the User
Preset. You can check the setting status of the User Preset
in [User Preset Status] (page 20) in the [User Preset
Setting] menu. The saving of the User Preset is
performed in [Save] (page 21) in the [User Preset
Setting] menu.
[Line Doubler]
Press the button to check the IP conversion with the Line
Doubler when displaying the interlace signal. Regardless
of the field, the interpolation that draws two lines in the
order that each data arrives is performed. This function
can be used to check the line flicker when creating a
telop as the line flicker can be seen.
26
Adjustment Using the Menus
Notes
 When [Line Doubler] is turned on, the scan setting is
disabled and switches to the native scan mode.
 It is recommended that [Screen Saver] is turned on
when using the Line Doubler, as the Line Doubler may
cause image smearing. (When the screen saver is
activated, [Line Doubler] switches off.)
[Sync-free Side by Side]
Press the button to display the two inputs of the digital
signal in the same screen side by side.
[HDMI]
Note
When [Sync-free Side by Side] is set to on, the scan
setting changes to the normal scan.
When [Sync-free Side by Side] is set to on, the following
functions turn off.
[Time Code]

[Marker]

[WFM/ALM/Vector]

 [Line Doubler]
The following functions are not available on the sub-
screen.
[False Color]

[Focus Assist]

 [Camera Metadata]
The only audio output is the input (embedded) audio
signal shown on the left side of the screen.
[Audio Muting]
Press to turn off the sound output. To turn on the sound,
press this once again or turn the volume up adjusting
[Volume] of the [User Control] menu (page 19).
[False Color]
Displays the colored image which shows the brightness
of the input signal. Press the button to display the image.
Notes
The False Color function is not available when the

RGB signal is input.
 The False Color function supports the OETF of 0.45
gamma (OETF of SDR). The function does not
[SDI1]