Sony LMD-A240 Operating Instructions Manual page 24

menu (see page 28).
SDI1
Note
When [Wipe] is set to on, the following functions turn
off.
 [Time Code]
 [Closed Caption]
 [Line Doubler]
[Wipe Position]
Press the button to change the boundary location. This
function is only available when the two inputs of the SDI
signal connected are displayed in the same screen.
SDI1 SDI2
Note
In the 2K signal, the scan setting changes to the normal
scan.
[WFM/ALM/Vector]
Press the button to display the WFM/ALM/vectorscope
display. Set the WFM/ALM/vectorscope display setting
in the [WFM/ALM/Vector Setting] menu (see page 29).
[WFM/VS Zoom]
Press the button to zoom in the WFM/vectorscope
display. Set the zoom setting in the [WFM/ALM/Vector
Setting] menu (see page 30).
[WFM Line Position]
Press the button to display the adjustment screen and
adjust the WFM line position. Press again to hide the
adjustment screen. However, the WFM line position
remains adjustable. Turn the menu selection control
right to lower the line position, or left to raise it.
[Time Code]
Press the button to display the time code display. Adjust
the settings for the time code display in [Time Code
Setting] (see page 28).
24
Adjustment Using the Menus
The image is displayed
with the left and right parts
connected at boundary
position.
SDI2
The boundary position can
be changed with the menu
selection control.
[Mono]
Press the button to display a monochrome picture.
When the buttons is pressed again, the monitor switches
automatically to color mode.
[Blue Only]
Press the button to eliminate the red and green signals.
Only blue signal is displayed as an apparent
monochrome picture on the screen. This facilitates
"chroma" and "phase" adjustments and observation of
signal noise.
[Scan]
Press the button to change the scan size of the picture.
With every press of the button, the picture switches in
the sequence [Normal] scan or [Native] scan.
480i, 575i, 480p, 576p
Vertical pixels are set to
1200 (LMD-A240), or
1080 (LMD-A220 and
LMD-A180). Horizontal
pixels are displayed with
scaling to the appropriate
aspect ratio.
When an NTSC or PAL
signal is input, the screen
may appear small
depending on the signal.
LMD-A240
480i, 575i, 480p, 576p,
1080i, 1080PsF, 1080p,
720p
LMD-A220/A180
1080i, 1080PsF, 1080p,
720p
Horizontal pixels are set
to 1920 and vertical pixels
are displayed with scaling
to the appropriate aspect
ratio.
When an NTSC or PAL
signal is input, the screen
may appear small
depending on the signal.