Table of Contents
Advertisement
FETCO
Ready to Brew
STOP
Brewing
6:45
STOP
See the following pages for the batch parameter definitions and all settings for the brewer
TBS-1221
Ver. 2.0.210317
STOP
TO ENTER PROGRAMMING
1-Turn brewer "OFF" from power switch
2-Turn power switch to "ON"
...Screen will initialize and then
display digital process notifications
3-After Initialization- "STOP" Lamp turns on
4-Quickly press "STOP" button (no need to hold)
Enter Programming to Make Changes
General Settings
B
STOP
Enter Programming-Press
From the "B" screen
STOP button until the
Press button 1 to toggle
General Settings ("B")
to the Tank Temperature
screen appears
Screen (default is 200°)
See the programming menu layout table on the next page to locate the desired control settings to adjust.
Batch size and menu brewing parameters are in section "A".
The most common settings for tank temperature setpoint , units of measure are in section "B".
Go to fetco.com for the latest versions of all information
Starting The Brew
1. Turn the power switch "ON".
2. Prepare a brew basket with the correct size filter and appropriate amount of tea.
3. Slide the brew basket completely into the rails.
4. Place a clean, empty, dispenser under the brew basket.
5. Select a batch & hold the corresponding BREW button in for 1 second to start
6. -STOP button will illuminate, Brew Selector button will illuminate
-Countdown time will display. Default time setting is 6:45(iced tea)
-Selected BREW button will slowly pulsate to indicate brew is in progress.
-All other BREW buttons for that brew head will be unlit.
7.Dilute DELAY cycle will activate at 3:45
8. Dilute will activate at 3:30.
Upon time out, brewer will return to "READY" for next batch
STOP button will extinguish and the BREW button will illuminate on completion
For safety- do not remove brew basket until drip-out is complete.
Enter Programming
There are 7 menu groups-A-F plus EXIT (G).
Section B –"General Settings" to change tank temperature shown below
Tank Temperature
B1
200°F+-
STOP
STOP
From Tank Temp screen
Toggle buttons 2 & 3 to
select the desired
temperature
STOP BUTTON
↓
When brewer is In PROGRAMMING MODE
-the screen will display:
ON/OFF switch
is located on
lower right on
-
back of brewer
Illuminated LED indicates active keypad positions
See the following pages for batch parameter definitions
Tank Temperature
B1
171° to 207°
STOP
From Tank Temp screen
Press button 1 to toggle
to the next selection in
General Settings or SAVE
User Guide & Operator instructions
Page 4
Batch Program
A
STOP
|BATCH PRG|
|A (or B-F) |
and all settings for the brewer
Brew at Temp
B2
YES-
H
STOP
To SAVE and EXIT
Press the STOP button to
the "H" screen. Proceed
to screen two below
P209 REV002 August 2023
EXIT
NO +
Advertisement
Table of Contents
