Starting The Brew; Enter Programming; Exit Programming & Save - Fetco CBS-1221 Users Manual And Operator Instructions

FETCO
Ready to Brew
STOP
Brewing
5:30
STOP
See the following pages for the batch parameter definitions and all settings for the brewer
CBS-1221
Ver.3.0.2019
STOP
TO ENTER PROGAMMING
1-Turn brewer "OFF" from power switch
2-Turn power switch to "ON"
...Screen will initialize and then
display digital process notifications
3-After Initialization- "STOP" Lamp turns on
4-Quickly press "STOP" button (no need to hold)
s
Programming A-F
A-F
STOP
From any screen-
Press STOP button
until the EXIT ("G")
screen appears
Go to fetco.com for the latest versions of all information

Starting The Brew

1. Turn the power switch "ON".
2. Prepare a brew basket with the correct size filter and appropriate amount of coffee.
3. Slide the brew basket completely into the rails.
4. Place a clean, empty, preheated dispenser under the brew basket.
5. Select a batch & hold the corresponding BREW button in for 1 second to start
6. -STOP button will illuminate, Brew Selector button will illuminate
-Countdown time will display. Default time setting is 6:00 (six minutes)
-Selected BREW button will slowly pulsate to indicate brew is in progress.
-All other BREW buttons for that brew head will be unlit.
7. When the brew cycle is finished,
STOP button will extinguish and the BREW button will continue to pulsate to indicate
DRIP will display to show the 2:00 (two minutes) drip delay setting.
This indicates that coffee may still be dripping from the brew basket
For safety- do not remove brew basket until drip-out is complete.

Enter Programming

There are 7 menu groups-A-F plus EXIT (G).
Exit Programming & Save Control Setting Changes
EXIT
G NO +
STOP
STOP
From the "G" screen
Press button 2 to
toggle to the EXIT-
YES screen
STOP BUTTON
↓
ON/OFF switch
is located on
lower right on
back of brewer
EXIT
G YES -
From EXIT screen From SAVE screen
Press button 1 to
toggle to the SAVE toggle to the SAVE-
screen
User Guide & Operator instructions
Page 3
Batch Program
A
STOP
When brewer is In PROGRAMMING MODE
-the screen will display:
|BATCH PRG|
|A (or B-F) |
-
Illuminated LED indicates active keypad positions
See the following pages for batch parameter
definitions and all settings for the brewer
SAVE
G NO +
STOP
STOP
To SAVE and EXIT
Press button 2 to
SAVE your changes
YES screen
OPERATING MODE
P194Re0
SAVE
G YES -
Press button 1 to
and EXIT to
November 2020