Table of Contents
Advertisement
Brewer Setup
Attach factory supplied Dual Water Inlet Connector Assembly. Install on each valve -Inlet and Dilution
Check that rubber washer is in adapter. Hand tighten only-and, if necessary, 1/4 turn with wrench
Part 1102.00488.00 Dual Water Inlet Connector Assembly
FETCO
Inlet valve
FETCO
Dilution valve
Install the adapter on the two valves first before attaching water line. Adapter is included in the carton.
Use of any other connector to valve will damage the valve
The valve threads are 3/4" BSP MALE THREAD and are not 3/4 garden hose fittings.
DO NOT use USA dishwasher water adapter or USA washing machine adapter for this connection.
The threads on any of these USA adapters are unusable for the valve
TO PREVENT DAMAGE AND INSURE PROPER EQUIPMENT OPERATION
The inlet valve thread is 3/4 INCH BSP (British Standard Pipe).
This valve is not a standard USA washing machine or dishwasher thread (¾" GHT)
-Use only the 1102.00488.00 plumbing adaptor kit included with this equipment.
-Use the washers included in adaptor kit
-Plumber's tape is not recommended for the adapter to valve connection
-Hand tighten adapter on valve with gasket, then very lightly wrench 1/4 turn to set
-DO NOT SUBSTITUTE FITTINGS FOR CONNECTING TO WATER SUPPLY
Damage to inlet valve from improper installation will void the warranty
NOTE: DO NOT PLUMB TANK DRAIN. DRAIN IS FOR SERVICE AND MAINTENANCE ONLY.
Go to fetco.com for the latest versions of all information
Inlet & Dilution Valve Notes
↑
Rubber washer
(Included with adapter)
Rubber washer
(Included with adapter)
↓
valve
adapter
User Guide & Operator instructions
Page 23
↑
1/4" Quick Connect X 1/4" Flare Adapter
This may be removed and replaced
with another connection.
P209 REV002 August 2023
Advertisement
Table of Contents
