Table of Contents
Advertisement
Daily use – TV transmitter
A detailed description of the TV transmitter and its functions can
also be found in the instruction manual of the TV transmitter:
www.sennheiser-hearing.com/tvcleartransmitter2
Switching on audio transmission
The transmitter starts or stops streaming automatically when you
switch the TV on or off (Auto On/Off).
▷
Switch on your TV or audio source.
▷
Switch on the TV transmitter by briefly touching the power touch
panel.
The transmitter automatically transmits the audio signal to the
paired "TVS 200 Earbuds".
When a transmission via the transmitter is taking place, the
transmitter's light indicator lights up green.
When the transmitter is not receiving an audio signal, the light
indicator lights up white.
30 seconds after the start of the transmission, the transmitter
sends a short beep sequence to the paired earbuds. This allows
you to detect an active transmission even if the transmitter is not
currently receiving an audio input signal.
Switching off audio transmission
▷
To stop the transmitter from transmitting the audio signal, simply
switch off the transmitter via the power touch panel.
If you leave the transmitter switched on, the TV is switched off and
the transmitter does not receive any audio signal for more than
3 minutes, the transmitter switches to standby mode. The transmit-
ter's light indicator will then light up white.
Adjusting the volume
We recommend using the volume control on the earbud for adjusting
the volume on a daily basis.
During initial setup, you can use the volume controls on the transmit-
ter to select a comfortable initial volume.
To reduce the volume:
▷
Press the volume touch panel –.
To increase the volume:
▷
Press the volume touch panel +.
Auto
ON
LED
Sennheiser TVS 200 Earbuds | 29
Daily use
Advertisement
Table of Contents
