Table of Contents
Advertisement
Configuring the TVS 200 Earbuds
Switching the earbuds on and off
ON
The earbuds switch on automatically when they are taken out of the
charging case. They switch off when they are reinserted into the
charging case and are fully charged.
The light indicators light up:
Light indicator
green
orange
red
If an earbud has switched off, it can be switched on again by briefly
pressing the button.
Setting the earbuds to pairing mode
1. Make sure that both earbuds are properly inserted into the
charging case.
2. Press the pairing button for 2 seconds until the light indicator
starts flashing blue.
1
2
Hold 2s
3. Wait until all 3 light indicators flash blue (this can take up to
10 seconds). Pairing mode ends after 8 minutes or when pairing
was successful.
Configuring the TVS 200 Earbuds
Meaning
Battery charge status ok (> 50 %)
Battery charge status 20 – 50 %
Battery charge status < 20 %, charge the
rechargeable battery
short press
Sennheiser TVS 200 Earbuds | 13
3 blue LEDs
Advertisement
Table of Contents
