Table of Contents
Advertisement
USB Bracket Installation
The system board includes a connector (CN12) for the optional
universal serial bus (USB) bracket.
external special connectors to support additional serial peripherals.
The USB bracket is an optional item.
Follow these steps to install the USB bracket:
1.
Remove the cover of an expansion slot on the housing rear
panel.
2.
Insert the USB bracket into the slot until it fits in place.
3.
Secure the bracket with a screw.
4.
Locate CN12 on the system board. See Figure 1-2.
5.
Attach the USB cable connector to CN12.
The USB cable is a 10-pin female connector. Note that one pin
on the connector is covered to ensure the correct orientation
when you attach it to CN12 which is an 8-pin connector.
Figure 1-3
USB Bracket Installation
System Board
The USB bracket has two
CN12
1-9
Advertisement
Table of Contents
