Setting Up
Up the
the Equipment
Equipment
Setting
Setting
Up
the
Equipment
1. Disconnect the abrasive hose at the cam and
groove with the abrasive ball valve closed.
NOTE:
NOTE:
NOTE: If the pot contains water and abrasive
(especially under pressure), releasing the cam
and groove with the ball valve open will cause an
unintentional release of abrasive.
2. Flush water through the pot and out the
disconnected abrasive ball valve before filling the
pot with water and abrasive.
334667B
3. Reconnect the abrasive hose.
4. Disconnect the pump inlet hose and flush the
5. Fill the water tank only with fresh water, then
6. Close the rinse, dump, and abrasive ball valves.
7.
Get other manuals https://www.bkmanuals.com
water tank to remove any remaining debris.
Reconnect the pump inlet hose.
open the inlet ball valve.
Operation
11