Installing The Transport Wheels; Engaging Or Disengaging The Transmission - Toro 04861 Operator's Manual

Installing the Transport
Wheels
1. Move the kickstand to the
T -W
RANSPORT HEEL
Kickstand (page 10)
2. Slide a wheel onto an axle
Figure 16
1. Axle
3. Pivot the wheel-locking clip
from center of the wheel, allowing it to slide
farther onto the axle.
4. Rotate the wheel back and forth until it slides
completely onto the axle and the locking clip is
secured in the groove on the axle shaft.
5. Repeat the procedure on the opposite side of
the machine.
6. Carefully lower the machine off the kickstand.
-S position; refer to
ERVICE
(Figure 16).
2. Wheel-locking clip
(Figure 16) away
Engaging or Disengaging
the Transmission
You can disengage the drum from the transmission to
allow the machine to be maneuvered. Disengage the
transmission when you need to move the machine
without starting the machine (e.g., performing
maintenance in an enclosed area).
Before you operate the machine, ensure that you
engage the transmission.
1. Locate the traction-engagement lever on the
transmission gearbox
g307661
1. Traction-engagement
lever—D
ISENGAGED
position
2. Transmission gearbox
2. Perform the following step to engage or
disengage the transmission:
•
Disengage the transmission: Rotate the
lever to the D
•
Engage the transmission: Rotate the lever
to the E
20
(Figure 14).
Figure 17
3. Traction-engagement
lever—E
NGAGED
position.
ISENGAGED
position.
NGAGED
g342962
position