Toro 04861 Operator's Manual page 10

Hour Meter
The hour meter (Figure
of hours that the key switch has been in the O
position. Refer to the meter for scheduling regular
maintenance.
InfoCenter LCD Display
The InfoCenter LCD display shows information about
your machine and battery pack, such as the current
battery charge, speed, diagnostics information, and
more (Figure 7).
For more information, refer to
LCD Display (page 15).
Lift-Assist Handle
Use the lift-assist handle
adjusting the handle height or to raise and lower the
kickstand.
Handle-Height Adjuster
Use the handle-height adjuster
handle height to a comfortable operating position. Pull
up on the adjuster and use the lift-assist handle to
raise or lower the handle height.
1. Handle-height adjuster
Kickstand
The kickstand (Figure
the machine. Use the kickstand when you install or
remove the transport wheels or the cutting unit.
•
T -W
RANSPORT HEEL
7) records the total number
Using the InfoCenter
(Figure 7) to help with
(Figure 8) to move the
Figure 8
9) is mounted to the rear of
-S position:
ERVICE
To use the kickstand to install the transport wheels,
put your foot on the kickstand while pulling up and
back on the lift-assist handle
N
CAUTION
The machine is heavy and can cause back
strain if lifted improperly.
Put your foot pressure down on the
kickstand and use only the lift-assist
handle to raise the machine. Attempting to
raise the machine onto the kickstand any
other way can cause injury.
•
C -U
UTTING
To prevent the machine from tipping backward
when removing the cutting unit, lower the kickstand
and push out the spring pin so that it keeps the
kickstand in the position shown in
1. Lift-assist handle
2. Kickstand—S
position
g271081
10
(Figure
-S position:
NIT ERVICE
Figure 9
3. Kickstand—T
S
ERVICE
TORAGE
9).
Figure 10.
g342960
-W
RANSPORT HEEL
position