Installing The Transport Wheels; Adjusting The Cutting Unit - Toro Greensmaster 1000 Operator's Manual

3. Thread the right wheel shaft into the drive pulley
on the right side of the machine
Note:
The right wheel shaft has left-hand
threads.
1. Right wheel shaft
4. Torque the shaft to 88 to 101 N∙m (65 to 75 ft-lb).
5. Repeat steps 2 through
shaft to the left side of the machine.
3
Installing the Transport
Wheels
Optional
Parts needed for this procedure:
2 Transport wheel
Procedure
1. Push the kickstand down with your foot and pull
up on the handle to support the machine on the
kickstand.
2. Slide a wheel onto an axle.
3. Pivot the wheel locking clip away from center
of the wheel, allowing it to slide farther onto the
axle (Figure 8).
(Figure
Figure 7
4 to install the left wheel
7).
g007595
1. Locking clip
4. Rotate the wheel back and forth until it slides
completely onto the axle and the locking clip is
secured in the groove on the axle shaft.
5. Repeat the procedure on the opposite side of
the machine.
6. Inflate the tires to 83 to 103 kPa (12 to 15 psi).
7. Carefully lower the machine off the kickstand.
4

Adjusting the Cutting Unit

No Parts Required
Procedure
Before operating the machine, complete the following
adjustments:
•
Leveling the Rear Drum to the Reel (page 35)
•
Adjusting the Bedknife to the Reel (page 36)
•
Adjusting the Height-of-Cut (page 37)
•
Adjusting the Grass Shield Height (page 38)
•
Adjusting the Cut-Off Bar (page 38)
10
Figure 8
g017591