Tightening The Handle-Isolation Hardware - Toro 04861 Operator's Manual

Figure 25
1. Front-cable jam nut
2. Rear jam nut
g342961
3. Brake cable
Tightening the
Handle-Isolation Hardware
Service Interval: After the first 20 hours
1. Position the machine on a level surface.
2. Loosen the bolt and nut as shown in
1. Bolt
3. Push the handle as far forward as possible.
4. While supporting the handle, torque the bolt and
nut that you loosened in step
(50 to 55 ft-lb).
Note:
Have an assistant help you to support
the handle or torque the hardware.
5. Release the handle.
29
Figure
Figure 26
2. Nut
2 to 68 to 75 N∙m
26.
g342963