1. Right wheel shaft
4. Torque the shaft to 88 to 101 N∙m (65 to 75 ft-lb).
5. Repeat the procedure on the left side.
4
Installing the Transport
Wheels (Optional)
Parts needed for this procedure:
2
Transport wheel (optional)
Procedure
1. Slide the wheel onto the axle
2. Pivot the wheel locking clip away from center of the
wheel allowing it to slide farther onto the axle
8).
Figure 7
(Figure
8).
g007595
1. Locking clip
3. Rotate the wheel back and forth until it slides
completely onto the axle and the locking clip is secured
in the groove on the axle shaft.
4. Repeat the procedure on the opposite side of the
machine.
5. Inflate the tires to 83 to 103 kPa (12 to 15 psi).
5
Adjusting the Cutting Unit
(Figure
No Parts Required
Procedure
Before operating the machine, complete the following
adjustments:
•
Leveling the Rear Drum to the Reel (page 31)
•
Adjusting the Bedknife to the Reel (page 31)
•
Adjusting the Height of Cut (page 32)
•
Adjusting the Grass Shield Height (page 33)
•
Adjusting the Cut-off Bar (page 33)
11
G017591
Figure 8
g017591