Stamina X AMRAP ROWER Owner's Manual page 13

COMPUTER INSTRUCTIONS
To wear the HEART RATE TRANSMITTER(116) around the chest, hook the hook end of the ELASTIC
SENSOR STRAP(117) to the other end of the ELASTIC SENSOR STRAP(117). Adjust the ELASTIC
SENSOR STRAP(117) to fit your chest snugly as shown in the illustration below. Apply water or conductive
gel to moisten the heart rate
contact with your chest skin to properly detect your heart rate.
(117)Elastic Sensor Strap
Hook
NOTE: If your heart rate is inconsistent or not tracking on your workout monitor, do the following:
The HEART RATE TRANSMITTER(116) will connect to the computer while using the unit and
within close proximity of the unit. If you are too far from the unit the connection will be lost.
Moisten the
and make sure they are in contact with the skin. Your skin may be dry when you begin your
workout and the moisture is necessary to ensure contact. As you sweat, contact will improve.
Tighten the elastic strap so it remains in place as you exercise. Movement of the
electrodes will result in inaccurate or erratic signal and readings.
Clean the
and water and dry with a soft towel.
Transmitter Care and Maintenance
Wash regularly with mild soap and water solution and dry with a soft towel being careful not to scratch
the heart rate sensor electrodes.
Store in a cool, dry place. Make sure the
and never store a wet transmitter in non-breathable material like a plastic bag or sports bag.
Do not stretch the
NOTE: The frequency of the receiver built into the STAMINA│X AMRAP ROWER is 5 kHz. All compatible
heart rate transmitters from other companies will work with the STAMINA│X AMRAP ROWER.
sensor electrodes. These
(117)Elastic Sensor Strap
sensor electrodes on the back of the ELASTIC SENSOR STRAP(117)
heart rate
heart rate sensor electrodes as dirt can interfere with transmission. Use a mild soap
heart rate sensor electrodes.
heart rate
heart rate sensor electrodes aren't stored with any wet material
13
sensor electrodes must be wet and in
heart rate sensor