Daikin FTXP20-71L Service Manual page 120

3 | Components
To remove the switch box
Service manual
120
2 Open the electrical wiring box cover by pulling the protruding part on the top
of the cover.
3 Unhook the tab(s) on the bottom and remove the electrical wiring box cover.
a
b
a
c
a Tab
b Protruding part on the top of the cover
c Screw
Prerequisite: Stop the unit operation via the user interface.
Prerequisite: Turn OFF the respective circuit breaker.
Prerequisite: Remove the required plate work, see
1 Disconnect the power supply wiring from the power supply terminal X1M.
2 Remove the screw and power supply wiring bracket.
3 Pull the clip and remove the heat exchanger thermistor from its holder.
4 Remove the screws to disconnect the grounding wires from the heat
exchanger.
a a
a Grouding wire screw
b Heat exchanger thermistor
c Indoor unit PCB
d Switch box screw
e Switch box
5 Disconnect the connectors of the indoor unit fan motor, the swing flap motor
and the swing raster motor (if equipped) from the indoor unit PCB.
3
"3.9 Plate
b
e
c
d
ATXP20~35 + FTXP20~71 + ARXP20~35 + RXP20~71
a
work" [ 4 111].
Split Comfora R32
ESIE18-01E – 2023.01