Table of Contents
Advertisement
Tonal Signals
On this model the {*} key on the ten
key pad is used as the Tone key.
Some organizations offer you a spe-
cial service by telephone, which you
can access by transmitting Touch tone
or DTMF tones. If your phone service
provides only pulse dialing, or if you
are calling over a digital network, the
ability to generate Tonal Signals will
allow you to access these services.
First, dial the other party. When you
are through to the other end, press the
Tone key and enter the code number
that is needed to access the required
feature at the other terminal. You do
not need to press the Tone key if your
machine is set up for dialing in Tone
Dial (DTMF) mode.
Using the tone key
A
Make sure that the machine is in
standby mode, and that there is
no document in the feeder.
B
Pick up the telephone handset, or
press the {On Hook Dial} key.
C
Dial the remote facility. Do not
press the {Start} key.
Note
If your telephone line type is
DTMF (Tone Dial), go to step E.
D
After your line is connected to the
remote facility, if your telephone
line type is Pulse Dial, press the
{*} key on the ten key pad.
A dot appears in the display.
E
Input the digits that you need to
use the remote facility. After you
have finished your business with
the remote facility, hang up.
Note
Do not press the {Start} key.
Tonal Signals
4
53
Advertisement
Table of Contents
