Figure 70
1. Feeler gauge
Figure 71
1. Feeler gauge
•
If the gap is less than 0.010 inch, then install
the shim and refer to Maintenance (page 30).
•
If the gap is sufficient, proceed to the safety
check in step F.
F. Perform the following safety check:
i. Sit on the seat and start the engine.
ii. Make sure the blades Do not engage with
the PTO switch "off " and the clutch
disengaged.
If the clutch does not disengage,
reinstall the shim and reference the
Troubleshooting section.
iii. Engage and disengage the PTO switch
ten consecutive times to ensure the clutch
is functioning properly. If the clutch
does not engage properly, reference the
Troubleshooting section.
Cooling System
Maintenance
Cleaning the Engine Screen
and Engine Oil Cooler
Service Interval: Before each use or daily
Remove any build-up of grass, dirt or other debris from the
oil cooler (Figure 72).
Before each use remove any build-up of grass, dirt or
other debris from the engine screen. This will help ensure
adequate cooling and correct engine speed and will reduce
the possibility of overheating and mechanical damage to the
engine.
Cleaning the Engine Cooling
Fins and Shrouds
Service Interval: Before each use or daily
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Clean the debris and grass from the engine parts.
46
Figure 72
G008804