Servicing The Fuses; Drive System Maintenance; Checking The Seat Belt; Checking The Rollover Protection System (Rops) Knobs - Toro Z Master Professional 5000 Series Operator's Manual

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check the
component/circuit for a malfunction or short.
1. The fuses are located on right hand console next to
the seat (Figure 59).
2. To replace the fuses, pull out on the fuse to remove it.
3. Install a new fuse (Figure 59).
Figure 59
1. Optional accesory
(15 amp)
2. Charge (25amp)
3. PTO (10amp)
g020464
4. Main (25amp)
5. Console
Drive System
Maintenance

Checking the Seat Belt

Service Interval: Before each use or daily
Visually inspect seat belt for wear, cuts, and proper operation
of retractor and buckle. Replace the belt before operating
if it is damaged.
Checking the Rollover
Protection System (ROPS)
Knobs
Service Interval: Before each use or daily
Check that both the mounting hardware and the knobs are
in good working condition. Make sure the knobs are fully
engaged with the ROPS in the fully raised position. The
upper hoop of the roll bar may need to be pushed forward or
pulled rearward to get both knobs fully engaged.
42