Replacing The Hydraulic Pump Drive Belt - Toro Z Master Professional 5000 Series Operator's Manual

Figure 76
1. Clutch pulley
2. Mower belt
3. Spring loaded idler pulley
4. Ratchet
10. Install the belt guide on the idler arm shown in Figure
76.
11. Using the ratchet in the square hole, install the idler
spring (Figure 76).
Note: Ensure that the spring ends are seated in the
anchor grooves.
12. Install the belt covers (Figure 77).
5. Square hole in the idler
arm for the ratchet
6. Idler grease zerk
7. Belt guide
1. Position the belt cover.
2. Slide the belt cover under
the side catches.
Replacing the Hydraulic Pump
Drive Belt
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Remove mower belt. Refer to Replacing the Mower
Belt (page 48) in Maintenance.
4. Raise the machine and support it with jack stands
(Figure 78).
49
Figure 77
3. Ensure that the tab is
under the metal catch.