Storage; Cleaning And Storage - Toro Z Master Professional 5000 Series Operator's Manual

Storage

Cleaning and Storage

1. Disengage the power take off (blade control switch
(PTO), set the parking brake, and turn the ignition key
to Off. Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine and hydraulic system. Clean dirt and chaff from
the outside of the engine cylinder head fins and blower
housing.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, engine, hydraulic pumps,
and motors.
3. Check the brake; refer to Adjusting the Parking Brake
(page 47) in the Maintenance Section.
4. Service the air cleaner; refer to Servicing the Air
Cleaner (page 33) in the Maintenance Section.
5. Grease the machine; refer to Lubrication (page 31) in
the Maintenance Section.
6. Change the crankcase oil; refer to Servicing the Engine
Oil (page 34) in the Maintenance Section.
7. Check the tire pressure; refer to Checking the Tire
Pressure (page 43) in the Maintenance Section.
8. Change the hydraulic filters; refer to Servicing the
Hydraulic System (page 53) in the Maintenance Section.
9. Charge the battery; refer to Servicing the Battery (page
40) in the Maintenance Section.
10. Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with
a garden hose.
Note: Run the machine with the blade control switch
(PTO) engaged and the engine at high idle for 2 to
5 minutes after washing.
11. Check the condition of the blades; refer to Servicing the
Cutting Blades (page 57) in the Maintenance Section.
12. Prepare the machine for storage when non-use occurs
over 30 days. Prepare the machine for storage as
follows:
A. Add a petroleum based stabilizer/conditioner to
fuel in the tank. Follow mixing instructions from
the stabilizer manufacturer. Do not use an alcohol
based stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and used at
all times.
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C. Stop the engine, allow it to cool, and drain the
fuel tank; refer to Servicing the Fuel Tank (page
40) in the Maintenance Section.
D. Restart the engine and run it until it stops.
E. Dispose of fuel properly. Recycle as per local
codes.
Important: Do not store
stabilizer/conditioned fuel over 90 days.
13. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
14. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
15. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it
out of reach of children or other unauthorized users.
Cover the machine to protect it and keep it clean.
61