Servicing The Engine Oil - Toro Z Master Professional 5000 Series Operator's Manual

Riding mower with 52in turbo force side discharge mower

Hide thumbs Also See for Z Master Professional 5000 Series:

Operator's manual (92 pages)

Setup instructions (16 pages)

Operator's manual (76 pages)

Table Of Contents

Table of Contents

8. Gently slide the primary filter out of the air cleaner

body (Figure 46).

Note: Avoid knocking the filter into the side of the

body.

9. Remove the inner filter only if you intend to replace it.

Important: Never attempt to clean the inner filter.

If the safety filter is dirty, then the primary filter is

damaged. Replace both filters.

1. Inner filter

2. Primary filter

3. Air cleaner cover

10. Inspect the primary filter for damage by looking into

the filter while shining a bright light on the outside of

the filter. Holes in the filter will appear as bright spots.

If the filter is damaged, discard it.

Servicing the Primary Filter

•

If the primary filter is dirty, bent, or damaged, replace it.

•

Do not clean the primary filter.

Servicing the Safety Filter

Replace the safety filter, never clean it.

Important: Never attempt to clean the safety filter.

If the safety filter is dirty, then the primary filter is

damaged. Replace both filters.

Installing the Filters

Important: To prevent engine damage, always operate

the engine with both air filters and cover installed.

1. If installing new filters, check each filter for shipping

damage. Do not use a damaged filter.

2. If the inner filter is being replaced, carefully slide it into

the filter body (Figure 46).

Figure 46

4. Latch

5. Air cleaner body

3. Carefully slide the primary filter over the inner filter

(Figure 46).

Note: Ensure that the primary filter is fully seated by

pushing on its outer rim while installing it.

Important: Do not press on the soft inside area

of the filter.

4. Install the air cleaner cover and secure the latches

(Figure 46).