Putting On Suunto Smart Sensor; Starting An Exercise - Suunto AMBIT3 PEAK 2.4 User Manual

Hide thumbs Also See for AMBIT3 PEAK 2.4:

Table of Contents

Suunto Ambit3 Peak

3.11.2. Putting on Suunto Smart Sensor

To start using the Suunto Smart Sensor:

1. Snap the sensor firmly into the strap connector.

2. Adjust the strap length as needed.

3. Moisten the strap electrode areas with water or electrode gel.

4. Put the strap on so that it fits snugly and the Suunto logo is facing up.

SUUNTO

The Smart Sensor turns on automatically when it detects a heart beat.

TIP: Wear the strap against your bare skin for best results.

Refer to the Suunto Smart Sensor User Guide for additional information and troubleshooting.

NOTE: Dry skin under the belt electrodes, a loose belt, and synthetic shirt materials can

cause abnormally high heart rate readings. Moisten the belt electrodes well and tighten the

belt to avoid heart rate peaks. If you are otherwise concerned about your heart rate, please

consult a doctor.

To start exercising:

1. Press [Start Stop] to enter the start menu.

2. Press [Next] to enter EXERCISE.

3. Scroll the sport mode options with [Start Stop] or [Light Lock] and select a suitable mode

with [Next] .

4. The watch automatically starts searching for a heart rate belt signal, if the selected sport

mode uses a heart rate belt. Wait for the watch to notify that the heart rate and/or GPS

signal have been found, or press [Start Stop] to select Later. The watch continues to

search the heart rate/GPS signal.

5. Press [Start Stop] to start recording your exercise. To access additional options while

exercising, keep [Next] pressed.

3. - 4.

SUUNTO

Table of Contents