Setting Necessary Parameters; Setting The Heating Mode - Potterton Eurocondense five 400 kW Installation Manual

5
xxxxxxxxxxxxxx
6
xxxxxxxxxxxxxx
7713465 - 05 - 23102019
5. Use the operating mode key for heating mode to select the automatic
operating mode on the boiler control unit
RA-0000163
6. Set the required room temperature using the control of the control unit
RA-0000164
8.2.3

Setting necessary parameters

Normally, the parameters of the regulator do not need to be modified. Only
date/time and individual time programs may need setting.
For DHW processing a setting of 55°C is recommended.
Important
Times for domestic water heating are set in time program 4 /
DHW. For reasons of convenience, domestic water heating should
start approx. 1 h before central heating commences.
8.2.4

Setting the heating mode

The operating mode key for heating mode enables a changeover between
the various heating operating modes. The selected setting is marked with
a bar underneath the operating mode symbol.
Automatic mode
Heating mode according to time program
Temperature setpoints
Protection functions (plant frost protection, overheating protection)
activated
Automatic summer/winter changeover (automatic switching over
between heating and summer operation from a certain outside
temperature onwards)
Automatic day heating limit (automatic changeover between heating and
summer operation, if outside temperature exceeds the room setpoint
value)
Continuous mode
Heating mode without time program
Protection functions activated
Automatic summer/winter changeover is not activated
Automatic day heating limit is not activated
Protection mode
No heating operation
Temperature according to frost protection setpoint
Protection functions activated
Automatic summer/winter changeover active
Automatic day heating limit active
or according to time program
or
8 Operation
65