Table of Contents
Advertisement
5 Before installation
2
1
1
36
5.10.5
1. Push the pallet truck forks through each of the rear and front transport
openings of the boiler.
2. Lift the boiler slowly and evenly using both pallet trucks
3. Move the boiler to the installation location and set it down
4. Remove both pallet trucks
2
1
RA-0000268
5.10.6
1. Place the pieces of pipe on the floor spaced at approx. 300 mm.
2. Lift the boiler onto the pipe pieces using a crane or pallet truck.
3. Move the boiler on the rollers to the installation room
3
RA-0000269
Moving by two pallet trucks
Danger
Risk to life due to boiler tipping!
When using pallet trucks make sure the weight is distributed
evenly on the forks.
Persons involved in transport must wear protective gloves and
safety footwear.
Caution
Risk of damage to boiler by impacts during transport!
The boiler must be protected against impact during transport. In
addition avoid pulling or pushing forces on the gas pipes or the
fan.
Transport on rollers
Caution
Risk of damage to boiler by impacts during transport!
The boiler must be protected against impact during transport. In
addition avoid pulling or pushing forces on the gas pipes or the
fan.
Important
The use of rollers for transporting the boiler is only possible on
completely even floors. Pieces of steel pipe with a width of approx.
1000 mm and a diameter of approx. 30 mm can be used as
rollers.
7713465 - 05 - 23102019
Advertisement
Table of Contents
