Table of Contents
Advertisement
7.5
Final instructions
7713465 - 05 - 23102019
3. Use a 3 mm Allen key to set CO
small load according to the
3.1. Clockwise: CO
3.2. Counter-clockwise: CO
4. Replace safety cap on the adjusting screw for small load
Important
After successful adjustment of the gas valve, the CO
must again be controlled at maximum and minimum output and
corrected if necessary
For more information, see
Technical data, page 14
Manual adjustment of burner output (controller stop function),
page 59
CO
content at max. output (EC five 610 kW)
2
1. In the control stop function (refer to the section
operate the EC five at maximum value
2. Set CO
-content with the adjustment screw for full load (2) according
2
Technical Data with a screwdriver
to the section
2.1. Clockwise: CO
2.1. Counter-clockwise: CO
CO
content at min. output (EC five 610 kW)
2
1. EC five In the control stop function (refer to the section
function ) operated at minimum value
2. Use a 2.5 mm Allen key to set CO
for small load according to the
2.1. Clockwise: CO
2.2. Counter-clockwise: CO
Important
After successful adjustment of the gas valve, the CO
must again be controlled at maximum and minimum output and
corrected if necessary
For more information, see
Technical data, page 14
Manual adjustment of burner output (controller stop function),
page 59
7.5.1
Instruction of the customer
The customer must be given full explanation of the heating system and
how the protective installations work. He must be especially instructed
about the following:
The supply air opening must not be closed or restricted
The connection nozzle for the combustion air at the top of the device
must be accessible for the chimney sweep
The following control checks himself that he has to perform himself:
Pressure check on the manometer
Check of the receiver under the blowpipe of the safety valve
Only an approved heating specialist may carry out the inspection and
cleaning work at intervals.
content at the adjustment screw for
2
Technical data
content is increased
2
content is decreased
2
Control stop function )
content is increased
2
content is decreased
2
content at the adjustment screw
2
Technical data
content is increased
2
content is decreased
2
7 Commissioning
content
2
Control stop
content
2
61
Advertisement
Table of Contents
